dnl	$FabBSD$
dnl	$OpenBSD: install,v 1.6 2008/08/06 18:20:55 miod Exp $
FabBSDInstallPrelude

FabBSDInstallPart2

FabBSDBootMsgs(,"wd0")

	You will next be asked for your terminal type.  If you are
	installing from a non-serial console, the default of "vt220"
	is correct.  If you are installing from a serial console
	you should choose the terminal type from amongst those listed.
	(If your terminal type is xterm, just use vt220.)

FabBSDInstallPart3

	Next you will have to edit or create a disk label for the disk
	FabBSD is being installed on.  If there are any existing
	partitions defined (for any operating system), and a disk label
	is not found, you will first be given an opportunity to run
	fdisk and create an FabBSD partition.

	If fdisk is being invoked on your behalf, it will start by
	displaying the current partitions defined and then allow you
	to modify this information, add new partitions and change
	which partition to boot from by default.  If you make a mistake,
	you will be allowed to repeat this procedure as necessary to
	correct this.  Note that you should make FabBSD be the active
	partition at least until the install has been completed.

FabBSDInstallPart4({:- If you have Linux partitions
	defined on the disk, these will usually show up as partition
	'i', 'j' and so on.-:})

	Note that all FabBSD partitions in the disk label must have an
	offset that makes it start within the FabBSD part of the disk,
	and a size that keeps it inside of that portion of the disk.  This
	is within the bounds of the 'c' partition if the disk is not being
	shared with other operating systems, and within the FabBSD fdisk
	partition if the disk is being shared.

FabBSDInstallPart5(wd0)

FabBSDInstallNet({:-CD-ROM, -:},nofloppy)

FabBSDFTPInstall

FabBSDHTTPInstall

FabBSDCDROMInstall

FabBSDDISKInstall({:-"wdN" or -:},,{:-, Linux (ext2) or MS-DOS-:})

FabBSDCommonFS

FabBSDCommonURL

fABBSDInstallWrapup

FabBSDInstallWrapupPart2

FabBSDCongratulations